Dual Motor Driver Electronic 5 Amp

This is a ready to use dual H bridge module for controlling 2 DC motors with 5 Amp capacity each or a Stepper motor at max. 5 amp/phase. These motor drivers can be used to control any small to big motors. High speed PWM is also supported. It can be directly connected to 4 microcontroller pins to control 2 DC motor or a Stepper motor in Bipolar mode.

Features

5 Amp. per motor capacity

Works with any circuit that gives 3 to 5 v high output

Soft Start and Stop provides long life to gearboxes.

Usage

Connect the 6 wires to circuits and 4 wires to Motors.

Upon giving the battery/power supply to circuit it will drive the motors as per the input from RC circuit / Microcontroller / PC output or any other circuit that gives 3-5 V output.

Pinouts:

Output section (Screwed connector)

Pin 1 : Motor 1 a

Pin 2 : Motor 1 b

Pin 3 : Motor 2 a

Pin 4 : Motor 2 b

Input Section (6 Pin male Header)

Pin 1 : Motor 1 forward

Pin 2 : Motor 1 – reverse

Pin 3 : Motor 2 forward

Pin 4 : Motor 2 reverse

Pin 5 : 5 V output (For external circuits like MCU Board)

Pin 6 : GND

Power Connector

Power Supply

Power Supply –