SeismicStream Seismometer Interface

SeismicStream Seismometer Interface

The SeismicStream Seismometer Interface is a low-cost solution to digitise signals produced by seismometers. Data from one of two input channels can be sent to a computer via a USB-C connection or via UART to a Raspberry Pi (when used as a HAT).

The firmware for the SeismicStream interface can be updated via USB

This affordable seismometer interface has been designed as a replacement for the old SeismicPi HAT. It provides an easy way to extract and make sense of the signals produced by either the Slinky Seismometer System or other commercial seismometers/geophones.

Sensors can be connected to the SeismicStream either via a 3.5mm jack or via a terminal block, providing compatibility for a large range of devices. The signals are processed on board, with help from an RP2040 chip and then sent onwards either via a USB-C connection (virtual COM port) or Raspberry Pi HAT (UART).

Data can be collected and interpreted using the jAmaSeis software

This pack includes:

• 1 x SeismicStream seismometer interface

You can combine the interface with a case and Raspberry Pi fixings set to provide protection to your interface, or mount it to a Raspberry Pi.